Radium Engineering – PVC Catch Can (S13 180SX)


SKU: 20-0725-FL Categories: ,


Radium Engineering – PVC Catch Can (S13 180SX)

Radium Engineering catch cans feature large 10AN ORB ports, a 4AN ORB drain port, 2-step oil separation baffling, and an O-ring sealed dipstick. These kits mount using factory holes and integrate perfectly with the surrounding components. They do NOT vent to atmosphere (VTA), thus are emissions and track legal. Closed loop systems remove the oil and sludge from the PCV gasses before it is routed to the engine to be burned. A closed loop system also promotes negative crankcase pressure for optimal performance. Furthermore, closed systems prevent unwanted oil vapors from entering the cabin. The dipsticks built into the catch cans allow easy inspection of accumulated fluid. No cutting, drilling or permanent modifications are required.


The PCV catch can kit runs inline between the PCV valve and the intake manifold. It mounts to threaded bosses on the RH strut tower just clear of the fuel filter. When the intake manifold pressure is close to or greater than atmospheric pressure, the PCV “check” valve closes and, thus, this hose experiences no flow. Conversely, the PCV hoses will experience “metered” vacuum when the engine is idling, steady state cruising, and decelerating. This would normally draw unwanted crankcase vapor, unspent fuel, and oil sludge into the intake manifold immediately after a high load run.


Radium Engineering – PVC Catch Can (S13 180SX) Inclusions:

  • Baffled oil catch can
  • Nissan specific mounting bracket
  • AN adapter fittings and hose ends
  • Stainless steel hardware
  • Radium PCV hose

Radium Engineering – PVC Catch Can (S13 180SX) Would Suit: 

  • 1988 – 1993 Nissan Silvia/180SX S13
  • 1994 – 1998 Nissan 180SX S13


There are no reviews yet.

Be the first to review “Radium Engineering – PVC Catch Can (S13 180SX)”

Your email address will not be published. Required fields are marked *