Haltech WB1 Single Wideband Controller Kit Length: 1.2M (4ft)


SKU: HT-159976 Categories: ,


Haltech WB1 Single Wideband Controller Kit Length: 1.2M (4ft)

The Haltech Wideband Controller is a plug and play wideband solution for your Haltech system. It allows users to accurately measure air/fuel ratios over a wide range, and deliver that information via CAN to a supported ECU of their choice. This product increases functionality of all Haltech NEXUS, Elite and Platinum ECUs with its plug and play CAN compatibility. It is easily programmed and controlled through NSP, ESP or ECU Manager software.

Smaller, lighter and water-proof! The new Haltech Wideband Controller can now be safely fitted inside your engine bay.

Suits: Bosch LSU 4.9 Sensor

Includes: Single Channel, CAN Wideband Controller, 4.9LSU Sensor, CAN Cable (4’/1200mm), Power Supply Cable, Weld-on Bung, Quick Start Guide.

Notes: The ideal CAN expansion accessory for all Elite Series ECUs.

WB1 Product Specifications

Size: 86mm x 77mm x 28mm / 3.39” x 3.03” x 1.10”
Sensor Compatibility**: Bosch LSU 4.9 or NTK LZA08-H5
Supply Voltage: 6.5V to 16V DC, Short circuit,reverse polarity protection
Supply Current: 650mA Typical / 4A Peak
Maximum Temperature: 85C (185F)
Communications: CAN (Haltech) with baud rate of 1Mbit/sec
Configuration: Haltech NSP Software, ESP Software, or ECU Manager
CAN Connection: 2 x DTM-4 Connectors / 1 x DTM04-6P Connection

** Sensors are compatible with specific WB1/WB2 Controllers. ie. NTK WB1 only compatible with NTK sensor.


There are no reviews yet.

Be the first to review “Haltech WB1 Single Wideband Controller Kit Length: 1.2M (4ft)”

Your email address will not be published. Required fields are marked *